Electrical Fixtures
Strip Lighting
Last Updated: April 25, 2025Strip Lighting: Flexible, low-profile LED tape lights used for task, accent, or under-cabinet lighting. Often adhesive-backed and low-voltage, requiring a driver for safe operation.
Motion Sensor Light
Last Updated: April 25, 2025Motion Sensor Light: A lighting fixture that automatically activates upon detecting movement. Used for security, pathways, or energy-saving in public and commercial areas. Sensors may use infrared, microwave, or dual technology.
Dimmer Module
Last Updated: April 25, 2025Dimmer Module: A device used to adjust light levels on compatible fixtures. Installed behind wall plates or within switchboards. Must match the load type (LED, incandescent, etc.) to prevent flicker or failure.
Timer Switch
Last Updated: April 25, 2025Timer Switch: A programmable switch that automatically turns appliances or lights on/off at set times. Used for energy savings and security lighting. Available in mechanical or digital models.
RCD Protected Outlet
Last Updated: April 25, 2025RCD Protected Outlet: A socket outlet with an integrated Residual Current Device (RCD) that automatically cuts power when it detects leakage. Common in outdoor, bathroom, and high-risk zones for electrical safety.
Appliance Inlet
Last Updated: April 25, 2025Appliance Inlet: A fixed connection point where a plug or cable supplies power to an appliance or machinery. Common in commercial kitchens and caravan setups. Typically matched with heavy-duty plugs.
Surface Socket
Last Updated: April 25, 2025Surface Socket: A type of outlet mounted on the surface of a wall or enclosure, rather than recessed. Used in garages, sheds, or industrial settings where recessing isn’t practical.
Heat Lamp
Last Updated: April 25, 2025Heat Lamp: A lamp that emits infrared radiation used for warming bathrooms or drying spaces. Installed in 3-in-1 bathroom fittings alongside light and fan units. Requires separate switching and high-heat rated wiring.
Weatherproof Enclosure
Last Updated: April 25, 2025Weatherproof Enclosure: A sealed box used to house electrical components outdoors or in damp environments. Typically rated IP55 or above and used for switchgear, GPOs, and control panels.
IP Rated Fittings
Last Updated: April 25, 2025IP Rated Fittings: Electrical components rated using the Ingress Protection (IP) system. Indicates resistance to dust and water. Common in outdoor and wet-area installations. E.g. IP65 = dust-tight and water jet resistant.
Waterproof GPO
Last Updated: April 25, 2025Waterproof GPO: A weatherproof general power outlet designed for outdoor use. Must be IP-rated (typically IP53 or higher) and RCD protected to comply with Australian standards.
Exhaust Fan
Last Updated: April 25, 2025Exhaust Fan: A ceiling or wall-mounted ventilation unit that removes moisture and odours from bathrooms, laundries, or kitchens. Requires appropriate ducting and wiring to a switch or timer.
Fan Controller
Last Updated: April 25, 2025Fan Controller: A wall-mounted control unit for ceiling fans. May include speed settings, reverse mode, and integrated light switch. Wired directly to the fan motor or via a capacitor.
Architrave Switch
Last Updated: April 25, 2025Architrave Switch: A slimline switch designed for narrow wall spaces like door frames or architraves. Used in tight spots where standard wall plates won’t fit.
Wall Switch
Last Updated: April 25, 2025Wall Switch: A fixed switch plate installed on walls to control lighting or appliances. Can be single, multi-gang, or integrated with dimmers and fan controllers. Must comply with AS/NZS 3133.
Emergency Light Fitting
Last Updated: April 25, 2025Emergency Light Fitting: A light designed to operate during power outages using internal battery backup. Required in commercial buildings to illuminate exits and egress paths per AS/NZS 2293 standards.
Fluorescent Fitting
Last Updated: April 25, 2025Fluorescent Fitting: A light fixture designed to house fluorescent tubes, often used in commercial or industrial settings for broad, even illumination. Must include a compatible ballast and diffuser for safe operation.
Recessed Downlight
Last Updated: April 25, 2025Recessed Downlight: A low-profile ceiling light installed into a hollow opening. Common in modern Australian homes for energy-efficient, minimalist lighting using LED technology. Requires fire-rated enclosures in insulated ceilings.
Pendant Light
Last Updated: April 25, 2025Pendant Light: A suspended light fixture that hangs from the ceiling, typically via a cord, rod, or chain. Used in kitchens, hallways, or above tables, they combine functionality and style.
Batten Holder
Last Updated: April 25, 2025Batten Holder: A type of light fitting designed to mount directly to ceilings or walls and hold a standard bayonet bulb. Often used in garages, basements, and utility rooms for its simplicity and affordability.